What gets installed

How low-carbon heating works, and what is actually installed in your home

What each system physically puts in your house, what it takes out, and the steps from first call to a working system — so nothing on installation day comes as a surprise.

The systems

What does each low-carbon heating system involve?

Four systems cover almost every Scottish home: an air source heat pump, a hybrid, high heat retention storage heaters, and solar-assisted hot water alongside any of them.

Air source heat pump

An outdoor unit draws heat from the outside air, even below freezing, and passes it into your radiators or underfloor heating through a water circuit. Indoors you get a hot water cylinder, controls, and sometimes larger radiators. The boiler is removed.

Hybrid heat pump system

A smaller heat pump is connected to your existing gas or oil boiler. Smart controls decide which one runs: the heat pump for everyday heating, the boiler on the coldest days or for big hot water demand. Less change indoors, but two systems to look after.

High heat retention storage heaters

Modern electric storage heaters charge overnight or at other off-peak times, hold the heat in a dense core behind heavy insulation, and release it through the day with thermostatic control. No pipes, no outdoor unit, no cylinder. They work best on a suitable multi-rate tariff.

Solar-assisted hot water

Either solar thermal panels that heat water directly in a twin-coil cylinder, or solar photovoltaic panels with a diverter that sends surplus electricity to the immersion heater. Either way, the sun does some of the work of heating water, mostly from spring to autumn.

Inside and outside

What will I see in and around the house afterwards?

It depends on the system. A heat pump is the most visible change; storage heaters and solar hot water are the least disruptive.

Outside

For a heat pump, an outdoor unit on a wall bracket or ground pad, with space around it for air to flow. For solar, panels on a suitable roof. Storage heaters need nothing outside.

Inside

A hot water cylinder and controls for a heat pump, sometimes larger radiators. Storage heaters replace existing heaters on the wall. Solar hot water may need a twin-coil cylinder or a diverter.

Removed

With a full heat pump conversion, the boiler and often the oil tank or LPG bottles go. A hybrid keeps the boiler. Old storage heaters are taken away when new ones are fitted.

Step by step

What happens from first call to a working system?

Six steps. The survey and heat loss calculation come before any price, and nothing is booked until you have the written quotation in front of you.

01

You send your details

Six questions on the form: name, phone, email, postcode, monthly bill and property type. A surveyor calls back within one working day to arrange a visit at a time that suits you.

02

The survey visit

The surveyor measures every room, looks at walls, windows, loft and floors, checks the electrics and the existing system, and discusses where an outdoor unit or cylinder could go.

03

Heat loss and design

A room-by-room heat loss calculation decides how much heat each room needs on a cold Scottish day. That figure sets the size of the system and shows which radiators need to change.

04

Your written quotation

You receive the options that fit your house, with the named equipment, itemised work and the trade-off of each one stated plainly. Nothing is booked until you decide.

05

Installation

Installation work is scheduled with you in advance. Expect some disruption indoors while pipework, radiators or a cylinder are fitted; storage heaters and solar involve much less. We install through MCS-certified partners.

06

Commissioning and handover

The system is set up, tested and balanced, and you are shown how to use the controls. You receive the paperwork, warranties and guidance on getting the most from it through a Scottish winter.

Before you start

Does my house need work before low-carbon heating?

Often, yes. Insulation and draught-proofing come first, because every system performs worse and costs more to run in a house that leaks heat. The survey says so plainly.

Loft insulation, cavity wall insulation where the walls allow it, draught-proofing around doors and windows, and sensible ventilation are the usual first jobs. In older solid stone houses, internal or external wall insulation is a bigger decision with its own trade-offs around moisture and character, and the surveyor will talk it through rather than assume.

Get a quote

Which low-carbon option fits your home?

Tell us six things about your home. A surveyor calls you back with the options that fit your house, with every trade-off stated.

By submitting this form you agree to be contacted by Low Carbon Heating Scotland about your enquiry. Low Carbon Heating Scotland is a trading name of Scot Energy Efficiency Ltd, company number 17408629, registered office 66 Paul Street, London EC2A 4NA.

See our privacy policy and cookie policy.

Reviewed by the Scottish Energy Efficiency team. Last updated: 28 October 2026.

We use cookies to understand how the site is used. See our cookie policy.