Costs and prices

What low-carbon heating costs in Scotland, and what drives the price

We do not publish a price list, because any figure given before a survey is a guess. This page explains exactly what moves the price up or down, so you can read a quotation with confidence.

Why no price list

Why is there no fixed price for a heat pump?

Because two houses of the same size can need very different systems. The price depends on heat loss, radiators, the hot water cylinder, pipe runs, electrics and fabric work. A confirmed price is given on your written quotation after a survey.

A figure quoted over the phone, without anyone measuring your rooms or looking at your walls, is either padded to cover the unknowns or low enough to win the job and rise later. Neither helps you. A survey turns the unknowns into line items you can check.

Installation cost

What decides the installation price?

Six things account for almost every difference between one quotation and the next.

01

How much heat the house loses

The single biggest driver. A room-by-room heat loss calculation sets the size of the heat pump or the number of heaters. A draughty stone cottage needs more output than a well-insulated bungalow of the same floor area, and more output costs more.

02

Radiators and pipework

Heat pumps run at lower water temperatures than a boiler, so some radiators may need to be larger. Narrow microbore pipework sometimes needs replacing. Your survey says room by room which radiators stay and which change.

03

Hot water cylinder

Most heat pump installations need a hot water cylinder. If you have a combi boiler today, there is no cylinder, and space has to be found for one — often in an airing cupboard, loft conversion or utility room.

04

Where the outdoor unit goes

A short, simple run from the outdoor unit to the cylinder costs less than a long run across a garden or through a thick stone wall. Flats and tenements may need permission from neighbours or the factor before anything is fixed to a shared wall.

05

Electrical supply

Older homes sometimes need a consumer unit upgrade, and some properties need the network operator to check the incoming supply. This is confirmed on the survey rather than guessed at.

06

Fabric work first

Loft insulation, draught-proofing or cavity wall insulation may be needed before any low-carbon system makes sense. That work is costed separately, and it often lowers the size, and therefore the price, of the heating system itself.

Running cost

What decides how much it costs to run?

Running costs depend on your tariff, how the system is set up, what fuel you are replacing, and whether you generate any of your own electricity.

Your electricity tariff

Heat pumps and storage heaters both run on electricity. A tariff with cheaper off-peak rates can change running costs considerably, and storage heaters in particular are designed around one.

Flow temperature and controls

A heat pump set up to run gently for longer at a low water temperature uses less electricity than one forced to run hot. Good commissioning and sensible controls matter as much as the hardware.

What you are replacing

Comparing against mains gas, heating oil, LPG or old storage heaters gives very different answers. Off-gas homes on oil or LPG usually have the clearest case; homes on cheap mains gas need a closer look.

Solar on the roof

Solar panels or solar-assisted hot water do not heat the house on their own, but they reduce how much electricity you buy. They are a separate decision and should be costed separately.

If you are weighing up the cost of replacing an oil boiler with a heat pump, the oil boiler replacement site covers that route in detail. For spreading the investment monthly, paying monthly with interest-free credit is explained on another site in the group. And for the broader picture of replacing your boiler with a heat pump or hybrid, that comparison sits there. Part of the Scottish Energy Efficiency network.

By option

How do the options compare on cost?

Each option moves cost to a different place. None is cheap at both ends.

Air source heat pump

The highest upfront cost of the electric options, because of the outdoor unit, cylinder and any radiator changes. Running costs depend heavily on the fabric of the house and how well the system is designed.

Hybrid system

Usually less upfront work than a full conversion because the existing boiler stays. You keep paying for gas or oil for part of the year, and you maintain two systems.

High heat retention storage heaters

Simple to fit with no pipes or outdoor unit, so upfront cost and disruption are low. Running costs rely on a suitable off-peak tariff and on the house holding its heat.

Solar-assisted hot water

Reduces how much energy you spend heating water, mainly from spring to autumn. It needs a suitable roof and a compatible cylinder, and it is costed as a separate decision.

Reading a quotation

What should a written quotation include?

A quotation worth signing names the equipment, itemises the work, and states what is not included. If something is vague, ask before you agree.

  • The make and model of the heat pump, heaters or panels, and the cylinder
  • The heat loss figure the design is based on
  • Which radiators are being replaced, room by room
  • Scaffolding, electrical work and making good, itemised
  • VAT treatment — zero percent VAT applies to qualifying domestic installations until 31 March 2027 under HMRC rules
  • Anything excluded, stated in writing
Get a quote

Which low-carbon option fits your home?

Tell us six things about your home. A surveyor calls you back with the options that fit your house, with every trade-off stated.

By submitting this form you agree to be contacted by Low Carbon Heating Scotland about your enquiry. Low Carbon Heating Scotland is a trading name of Scot Energy Efficiency Ltd, company number 17408629, registered office 66 Paul Street, London EC2A 4NA.

See our privacy policy and cookie policy.

Reviewed by the Scottish Energy Efficiency team. Last updated: 28 October 2026.

We use cookies to understand how the site is used. See our cookie policy.