Much of the city is sandstone tenement flats, where shared walls, back courts and common closes mean an outdoor heat pump unit needs the agreement of neighbours or the factor. Storage heaters or a carefully planned communal approach are often more practical than one unit per flat. Victorian villas in the West End and South Side have high ceilings and large rooms that make a proper heat loss calculation essential.
Read the Glasgow guide →Large parts of the city sit in conservation areas, and many Georgian and Victorian homes are listed, so the position and visibility of an outdoor unit or solar panels needs checking against planning rules first. Tenement and colony flats share the same communal questions as Glasgow. Post-war bungalows and newer estates on the edges of the city are often simpler candidates for a heat pump.
Read the Edinburgh guide →Granite homes have thick solid walls that hold heat well once warm but lose it steadily without insulation, and wall insulation in granite needs care around moisture. Coastal towns face strong winds and salt air, which affects where an outdoor unit is sited and what protective finish it needs. Rural Aberdeenshire has many homes on heating oil, where the case for change is often clearest.
Dundee mixes stone tenements, inter-war and post-war council housing, and larger Victorian villas around Broughty Ferry and the West End. Many ex-council semis and terraces have cavity walls and straightforward layouts that suit a heat pump once insulation is up to standard. South-facing slopes above the Tay can make solar-assisted hot water worth a look.
Read the Dundee guide →Perth itself has a mix of Victorian sandstone villas and modern estates, while rural Perthshire has farmhouses, steadings and cottages off the gas grid, often heated by oil, LPG or solid fuel. Larger detached rural homes usually have space for an outdoor unit and cylinder, but older stone walls make the fabric survey especially important.
Long heating seasons and exposed sites make good fabric and correct sizing more important here than almost anywhere. Many Highland homes are off the gas grid and rely on oil, LPG or older storage heaters, so a heat pump or high heat retention storage heaters can replace an expensive fuel. Newer timber-frame houses around Inverness are often well suited.
Stirling, Falkirk and the surrounding towns combine historic stone properties in the older centres with large areas of post-war and modern housing. Conservation areas around the old town need the same planning checks as Edinburgh, while newer estates with cavity walls and modest heat loss are typically simpler installations.
Former mining towns in central and west Fife have a lot of ex-council terraces and semis with cavity walls, which often suit a heat pump after insulation. The East Neuk fishing villages have small, older stone cottages in conservation areas, where space for a cylinder and the look of an outdoor unit are the main questions.
Read the Fife guide →Coastal towns from Largs to Girvan face wind and salt air, which shapes where external equipment can go. Inland, Ayrshire and Dumfries and Galloway have many farmhouses and cottages off the gas grid, where replacing oil or LPG is the usual starting point and space outdoors is rarely the constraint.
Stone-built towns such as Hawick, Galashiels and Kelso, plus scattered farms and cottages, mean solid walls and off-gas heating are common. Rural properties often have the space for a heat pump and roof area for solar, but older fabric needs assessing before the system is sized.
Island and peninsula homes are often off the gas grid and fully exposed to Atlantic weather, so outdoor units need sheltered siting and coastal protection. Surveys and installations are planned around ferry times and access, which we discuss with you at the start rather than after booking.